DC5-8.4V 6 Channel Knob Servo Controller Control Board Robot Arm Manipulator

Description

Home
Arduino
Module
Sensor
Chips
About Us
Product introduction:
Using imported high-precision potentiometers, 6 energy machines can be controlled 1 to 1 with real-time synchronous 1:1 control.
There are over-current protections for the 3 channels of No. 0, No. 1, and No. 2 of the control board to prevent the steering gear from being burnt out due to excessive current.
There is a small button under each knob of the control panel. Press it once and the steering gear will be in the centered state, and the knob cannot control the rotation of the steering gear; press it again to release the centered state, and the knob can continue to control the rotation of the steering gear.
Wiring instructions:
+: Connect 5~8.4V power supply
—: Connect to the negative pole of the power supply
Generally speaking, the steering gear to be controlled needs a few V, just connect a few V to the control board.
Package Included:
Servo controller X1
Payment
Shipping
Refund
Payment
We accept PayPal only.
But we only
Accept
your
Ebay Address
,Please Make sure it's 100% right.
Payment must be received in 5 business days of auction closing.
Please leave note for your special request (e.g. Colors or Size) in PayPal when you pay the order.
Any special request cannot be accepted after 24 hours of payment, because most of orders will be processed instantly and same day dispatched.
Shipping
Fill your shipping info
Refund
All package need to
wait 30 days
(US only n
eed 7-10 days)
,
Please take care it.Less than 30 days,we can't take a refund
.
If the item is defect when you receive it or you are not satisfied with it, please return it within 14 days for a replacement or money back. But the items must be back in factory condition. Please contact us and double check the return address before you return it.
If is item is defective in 12 months, you can return it to us. We will send you a new replacement after receiving the defective item.